Gen #1 — AFCI 20A (Master + Living Front)
Wire: #12 Cu THHN (Black/White/Green). EMT ¾″ set-screw. Keep receptacle center ~16″ AFF.
- Panel → LR-F1 (Living Room, front wall left)
- LR-F2 (Living Room, front wall right)
- MB-1 (Master, back wall)
- MB-2 (Master, toilet wall)
- MB-3 (Master, bathtub wall)
- MB-4 (Master, front-side wall)
- LR-M (Living Room, shared wall to Master)
Straps: ≈ every 8 ft and ≤3 ft from boxes. Add bushings at panel and first box.
Gen #2 — AFCI 20A (Bedroom 2 + Living Back)
Wire: #12 Cu THHN (Red/White/Green) to distinguish circuit from Gen #1.
- Panel → LR-B1 (Living Room, back wall left)
- LR-B2 (Living Room, back wall right)
- B2-F1 (Bedroom 2, front wall left)
- B2-F2 (Bedroom 2, front wall right)
- B2-A (Bedroom 2, A/C/far wall)
- B2-BathWall (Bedroom 2, bathroom wall)
Label devices with circuit # at rough-in (painter’s tape). Final label stickers later.
Kitchen SA #1 — GFCI 20A (Counter + Refrigerator)
Small-Appliance required. First device GFCI feeds downstream (unless individual GFCIs).
- Panel → K-GFCI-C1 (Countertop left — GFCI)
- K-C2 (Countertop right — fed from LOAD)
- K-REF (Refrigerator outlet, dedicated on SA #1)
If fridge manufacturer requires dedicated/non-GFCI: land on separate 20A or use non-GFCI here per specs.
Kitchen SA #2 — GFCI 20A (Island + Washroom)
- Panel → K-GFCI-ISL (Island — GFCI)
- K-WS (Washroom area receptacle — fed from LOAD)
Island requires GFCI. Confirm box type (floor pop-up vs. cabinet side).
Bathrooms — GFCI 20A
- Panel → MBath-GFCI (Master bathroom)
- HallBath-GFCI (Hall bathroom)
Either single 20A bath circuit serving both GFCIs, or split to two 20A bath circuits.
Save Edits
This page saves your ordered lists to this device (localStorage). Works offline.