Square Bidness Install Method

1. Philosophy

The Square Bidness Install Method was born out of necessity — building HQ1, HQ2, and Start2Finish projects with no shortcuts and no wasted motion. It’s a discipline that blends tech, construction, and brand precision.

• Start clean — workspace prepped, tools staged, floor protected.
• Move with intention — every cut, every device, every wire has a purpose.
• Document everything — photos, notes, breaker maps, plate counts.
• Finish like a brand — level screws, consistent plates, flush fixtures.

2. Sequence (The SB Workflow)

• Measure — snap lines, find center, confirm beams.
• Pre-wire on the ground — harness built before attic entry.
• Cut & clear — precise holes, no guessing.
• Install — device → plate → alignment check.
• Test — neutral, load, ground continuity.
• Photograph — proof for lenders, records, and marketing.

3. Field Rules

• No rushing — one clean pass beats three sloppy ones.
• No unsafe loads — heaters on 20A lanes only.
• No dirty runs — wires organized, boxes clean.
• No untested work — tester must confirm the finish.
• No guessing beams — always probe or pilot.

This is how Square Bidness protects property, reputation, and future infrastructure.

4. Application

The Install Method is active across:

• HQ1 upgrades (recessed lighting, fan, outlets)
• HQ2 electrical & LVP work
• Start2Finish field projects (Brady house)
• Upcoming 40×50 slab data center build